EVOnet network camera Manuel d'instructions télécharger pdf (Page 15)

Network Camera

Manual Iris Lens

1. Remove the protective cover from the camera.

2. Mount the lens on the camera by turning the lens clockwise.

3. Turn the iris ring on the lens to the open position and adjust the iris properly.

DC-Type Auto Iris Lens

1. If necessary, solder the lens control wires to the connector socket supplied with the lens.

NOTE: Please refer to the lens manufacturer’s manual for soldering the lens control wires.

① Connector Socket Cover

② IRIS Control Cable

③ Connector Socket

④ Heat Shrink Tubing

PIN Name

Damp Coil –

Damp Coil +

Drive Coil +

Drive Coil –

2. Remove the protective cover from the camera.

3. Mount the lens on the camera by turning the lens clockwise, and then connect the auto iris jack

to the auto iris lens connector.

Use the lens of which the auto iris jack is long.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 57 58

Pas de commentaire

EVOnet network camera Manuel d'instructions Page 15